Metrologic Instruments IS8000 Manuel D’Utilisation

 

 

3

 

 

To avoid potential problems, do not power up the scanner until the 
communication cable is secured to the host. 

 
1.  Turn off the host system. 

 

2.  Connect the communications 

cable to the HoloTrak

®

 and 

to the host. 

 

3.  Check the AC input 

requirements of the power 
supply to make sure the 
voltage matches the AC 
outlet. 

 

4.  Plug the power supply to  

the scanner.  

 
5.  Plug the power supply into  

the AC outlet to supply  
power to the scanner. 

 

6.  Power up the host system. 
 
 
 

 

The primary/secondary feature gives the ability to connect or "daisy-chain" two 
scanners together to act as one scanner interfacing with only one host.  

 
 

 

12” (305 mm) to 24” (610 mm) 

12” (305 mm) coverage per conveyor 

22" (559 mm) to 44" (1118 mm) 

22” (559 mm) coverage per conveyor 

22" (559 mm) to 44" (1118 mm) 

22” (559 mm) coverage per conveyor 

18” (457 mm) to 36” (914 mm) 

18” (457 mm) coverage per conveyor 

Continued on next page 

 

 

To maintain compliance with applicable standards, all circuits connected to the scanner must meet 
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1. 

 

To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950, 
the power source should meet applicable performance requirements for a limited power source.