3com 09-1324-000 Manuel D’Utilisation

C

HAPTER

 6: C

ONFIGURING

 B

ASIC

 S

ETTINGS

The user interface provides help menus as memory aids. To display the help menu, 
enter a question mark (?). The question mark can be used with different options as 
described in Table 6-5.

You must set up the port that accesses the server for IP routing. To set up IP 
routing, follow these steps:

1 Log on as root and press the Return key.

The password prompt is displayed.

2 At the password prompt, press the Return key.

The network manager prompt (NETBuilder #) is displayed.

3 Set up an IP address and subnet mask using:

SETDefault !<port> -IP NETaddr = <IP address> [<subnet mask>]

XNS

Consists of a network address followed by a MAC address. The 
network address distinguishes between different XNS Ethernet 
networks. It contains eight hexadecimal digits, and is preceded by an 
ampersand (&), which is used for identification. Leading zeros can be 
omitted. The following addresses are the same:
&3333%080002001326
&00003333%080002001326

Online Help Syntax Summary 

?

Displays the help menu. Different commands are displayed de- 
pending on whether Network Manager privilege or User privilege is in 
effect. The commands are organized according to services.

-?

Displays a list of services.

-service?

Displays a list of commands within the service.

For example, to display a list of commands in the SYS Service, enter:

If there are no commands under the service, a message is displayed to 
indicate this. For example, enter this command at the prompt:

A message similar to the following appears:

No commands available in IDP service

command -service?

Displays a list of parameters that can be used with the command 
within the service.

For example, to display a list of PORT Service parameters that can be 
used with the SETDefault command, enter:

command ?

Displays parameters by service name that can be used with the 
command. Only parameters in services specified by the CurrentServices 
parameter are displayed.

command -service 
parameter?

Displays syntax for the command used with the parameter.

For example, to display the syntax for the SETDefault command used 
with the CONTrol parameter in the SNMP Service, enter: