3com 09-1324-000 Manuel D’Utilisation

For more information on IP configuration, refer to Reference for NETBuilder Family 
Software.

4 Enable IP routing by entering:

5 Enable a routing protocol. For example, to enable RIP use:

SETDefault !<port> -RIPIP CONTrol = (Listen, Talk)

6 Ensure your configuration by verifying that the bridge/router can access other 

devices on the network, use:

PING <IP address>

where <IP address> is the IP address of another device on the network. 

Configuration parameters are stored in flash memory or on the disk of another 
server (for example, the TFTP/FTP server that boots the bridge/router). In this 
guide, the term “disk” refers to either the local flash memory drive or the hard 
disk on another server. 

When the bridge/router is booted, it copies configuration parameters from the 
disk to memory. Parameter values on the disk are default values and values in 
memory are active values. You can alter the default and active values with the 
SETDefault and SET commands. For more information, refer to Reference for 
NETBuilder Family Software.

When the new value of a parameter takes effect depends on whether its active 
value has been changed. Some commands change the active value only, some 
change the default value, and some change both. If you display the parameter 
after modifying it and see the new value, the new value has taken effect 
immediately. If a command changes only the default value, the new value takes 
effect only after reboot. In this guide, if the description does not specify when the 
new value of a parameter takes effect after being enabled or disabled, it is 
effective immediately after it is set.

Before changing the Network Manager password, you must obtain Network 
Manager privilege. 

To display or change the privilege level, follow these steps:

1 To determine the current privilege level, enter:

If the following message is displayed, you already have Network Manager 
privilege:

PRIvilege = NetMgr

If the following message is displayed, go to step 2:

PRIvilege = User

You also can determine the privilege level from the NETBuilder prompt. The 
following prompt is displayed at the Network Manager privilege level:

NETBuilder #