Mitsubishi Electronics JT-SB216JSH-H-E Manuel D’Utilisation

− 8 −

Terminal  

block 

screw

Ground wire

Power 
cable

Terminal 
block 

4

Hole

Power cable

Power cable

5

70mm

15mm

Power cable hole

Power cable

Mounting 

screw

Cord clip 
(Included) 

Cord clip mounting screw hole

2.Screw the power cable to the terminal block.

Proper torque is 1.2Nm(11 lbf·in) 

Screw

Power cable

Run the power cable through the hole in the back 
of the appliance, and pull it through the appliance. 

Wire it to the terminal block. (No polarity) 
1.Remove 15mm of wire sheath from the end.

3.Check that the power cable is securely fixed 

to the terminal block. 

4.Wire the ground wire to the center terminal 

of the terminal block. 

Proper torque is 1.2Nm(11 lbf·in) 

5.Clip and screw the power cable into the 

position shown on the right.

Use single-phase 220-240V power.

Using the incorrect power supply may cause fires, electric shocks or 

malfunctions.

Terminal 

block