Dolmar PC-6430 Manuel D’Utilisation

Place the spring washer (8) on the arbour and insert the screw

(9) and tighten by hand.
Turn the disc slowly until the stop hole of the V-belt pulley is

visible in the cutting arm cover (10).
Insert the Allen key (2) as far as it will go. The shaft is now

blocked.
Tighten the screw with the combination wrench (1)

NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise

the cutting wheel may slip during cutting.

Mounting the cutting disc

Inspect the disc for damage.

See SAFETY INSTRUCTIONS, Page 7.
Unscrew screw (9) and remove the spring washer (8).
Place the cutting disc (5) on the arbour (7).
Hinweis: The arbor hole of the cutting disc must be an exact

fit with the arbor or shaft. If the arbor hole is larger, it must be

fitted with an adapter ring (*).

Make sure the cutting disc is installed so it turns in the right

direction, if a direction is marked on the disc.

PUTTING INTO OPERATION

CAUTION:

Always turn off the engine and pull off the spark plug cap

before doing any work on the Power Cut! Always wear

protective gloves!

CAUTION:

Start the Power Cut only after complete assembly and

inspection.

Sequence

For the the following work, use the assembly tools included

with delivery:
1.  13/19 AF combination wrench
2.  Allen key
3.  Carburetor adjustment screwdriver
4.  Adapter ring (not in the general delivery inventory)
Place the Power Cut on a stable surface and carry out the fol-

lowing assembly steps:

Only for models PC-8135 and 8140
No air filter is installed!

Before operation, insert an oiled foam

filter (pre-filter), as shown in the adja-

cent illustration! To do this, take off the

filter cover (see the chapter on Cleaning /

changing the air filter).