Dolmar PC-6430 Manuel D’Utilisation

MAINTENANCE

CAUTION:

Before doing any work on the Power Cut turn off the engine,

remove the cutting disc, pull the plug cap off the spark plug

and wear protective gloves!

CAUTION:

Start the Power Cut only after complete assembly and

inspection.

IMPORTANT:
Because many of the parts and assemblies not mentioned

in this Instruction Manual are vital to the safety of the unit,

and because all parts are subject to a certain amount of

wear and tear, it is important for your own safety that you

have the unit checked and maintained regularly by a DOL-

MAR service center.

IMPORTANT:

If the cutting wheel breaks during cutting, the Power

Cut must be repaired by a DOLMAR service centre

before being used again!

SERVICE

Unscrew the screws (8) and remove the crankcase housing

cover (9).
Remove the old belt (10) or belt pieces.
NOTE: The illustration shows the V-belt for models PC-6430

- 7335).
Clean out the inside of the drive arm with a brush.
Put in a new V-belt.
NOTE:
Reassemble the crankcase housing cover (9), side piece (6)

and cover (4) in the reverse order.
To tighten the V-belt see ”Tightening the V-belt / Checking

V-belt tension”.

Changing the V-belt

Loosen nuts (3).
Loosen the tightening screw (1) (counter-clockwise) until the

end of the screw (2) is visible in the gap.
Loosen and unscrew the screw (detail X, only for PC-8140).
Unscrew the nuts (3) and remove the cover (4).
Remove the screws (5) and (7) and remove the side piece

(6).
NOTE:

Screw (5) is longer than screws (7). Make sure

to put them back in the right places during reas-

sembly!