Wagner SprayTech 3.23 Manuel D’Utilisation

 

12 

ProSpray 3.23

Cleaning the unit (shutting down)

 1.  Screw off the filter (Fig. 7) from suction pipe.

 2.  Clean or replace the filter.

Carry out cleaning with a hard brush and an appropriate cleaning 

agent.

Clean the filter cartridge regularly.

A soiled or clogged high-pressure filter can cause a poor spray

pattern or a clogged tip.

  1.  Turn the pressure control knob counterclockwise to 

minimum pressure.

  2.  Open the relief valve, valve position PRIME 

 (k circulation).

  3.  Switch the unit OFF.

 4.  Unscrew the filter housing (Fig. 8, Item 1). with a strap

wrench.

 5.  Pull the filter cartridge (2) from the bearing spring (3).

  6.  Clean all the parts with the corresponding cleaning agent. 

If necessary, replace the filter cartridge.

 7.  Check the O-ring (4), replace it if necessary.

 8.  Place the bearing ring (5) against the bearing spring (3).

Slide the filter cartridge (2) over the bearing spring.

 9.  Screw in filter housing (1) and tighten it as far as possible

with the strap wrench.

  1.  Rinse Airless spray gun with an appropriate cleaning 

agent.

  2.  Clean tip thoroughly with appropriate cleaning agent so 

that no coating material residue remains.

  3.  Thoroughly clean the outside of the Airless spray gun.

 1.  Pull protective guard (1) forward vigorously.

 2.  Screw grip (2) out of the gun housing. Remove intake filter

(3).

 3.  Intake filter congested or defective – replace.

 1.  Place intake filter (3) with the long cone into the gun

housing.

 2.  Screw in grip (2) into the gun housing and tight en.

 3.  Slot in protective guard (1).

  W

arn

ing:

kee

p cl

ear

     o

f tip

      

   25

0 ba

r

max

.360

0 ps

i

Uncontrolled Copy