Ryobi CS26 RY28020 Manuel D’Utilisation

7 — English

If any parts are damaged or missing do not operate this 
product until the parts are replaced. Use of this product 
with damaged or missing parts could result in serious 
personal injury.

Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any 
such alteration or modification is misuse and could result 
in a hazardous condition leading to possible serious 
personal injury.

To prevent accidental starting that could cause serious 
personal injury, always disconnect the engine spark plug 
wire from the spark plug when assembling parts.

Never install, remove, or adjust any attachment while 
power head is running. Failure to stop the engine can 
cause serious personal injury.

The attachment connects to the power head by means of 
a coupler device.


  Loosen the knob on the coupler of the power head shaft 

and remove the hanger cap from the attachment.



  Push in the button located on the trimmer attachment. 

Align the button with the guide recess on the power 
head coupler and slide the two shafts together. Rotate 
the trimmer attachment until the button locks into the 
positioning hole.

 

NOTE: If the button does not release completely in the 
positioning hole, the shafts are not locked into place.  
Slightly rotate from side to side until the button is locked 
into place.



  Tighten the knob securely.

Be certain the knob is fully tightened before operating 
equipment; check it periodically for tightness during use 
to avoid serious personal injury.

For removing or changing the attachment:


  Loosen the knob.



  Push in the button and twist the shafts to remove and 

separate ends.

See Figure 4.
There are two ways to hang your attachment for storage:
 To use the hanger cap, push in the button and place 

the hanger cap over end of trimmer attachment. Slightly 
rotate the cap from side to side until the button locks into 
place.

  The secondary hole in the trimmer attachment can be 

used for hanging purposes as well.

See Figure 5.


  Remove wing nut, washer, and bolt from the front 

handle.



   Install the front handle onto the top side of the drive shaft 

housing in the area indicated by the label.

  

NOTE: The open side of the handle should face the 
operator. 



  Place the bolt through the front handle.

 

NOTE: The hex bolt head fits inside the hex recess molded 
into one side of the handle.



  Reinstall the washer and wing nut.



  Tighten wing nut securely.

The line cutting blade on the grass deflector is sharp. 
Avoid contact with the blade. Failure to avoid contact 
can result in serious personal injury.

See Figure 6.


  Remove hex screw, washer, and wing nut from grass 

deflector.



  Press the grass deflector onto the bottom of the curved 

shaft as shown.



  Insert the hex screw through the grass deflector and the 

bracket on the curved shaft.



  Place the washer on the hex screw.



 Place the wing nut on the hex screw and tighten 

securely.