Ryobi CS26 RY28020 Manuel D’Utilisation

8 — English

See Figure 7.


  Remove the wing screw from the grass deflector.



  Insert the tab on the mounting bracket in the slot on the 

grass deflector.

Do not allow familiarity with this product to make you 
careless. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1, along with hearing protection. 
Failure to do so could result in objects being thrown into 
your eyes resulting in possible serious injury.

Never use blades, flailing devices, wire, or rope on this 
product. Do not use any attachments or accessories not 
recommended by the manufacturer of this product. The 
use of attachments or accessories not recommended 
can result in serious personal injury.

FUEL MIXTURE
This product is powered by a 2-cycle engine and requires 
pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded 
gasoline and 2-cycle engine lubricant in a clean 1 gallon 
container approved for gasoline.
Recommended fuel: This engine is certified to operate on 
unleaded gasoline intended for automotive use.
Mix a high quality 2-cycle engine lubricant at 2.6 oz. per 
gallon (US).
Do not use automotive lubricant or 2-cycle outboard  lubricant.
DO NOT mix quantities larger than usable in a 30 day period.

 

 

1 gallon (US) 

2.6 oz.

 

1 liter 

20 cc (20 ml)

FILLING TANK


 Clean surface around fuel cap to prevent 

contamination.



 Loosen fuel cap slowly. Rest the cap on a clean 

surface.



  Carefully pour fuel into the tank. Avoid spillage.



  Prior to replacing the fuel cap, clean and inspect the 

gasket.



  Immediately replace fuel cap and hand tighten. Wipe up 

any fuel spillage.

NOTE: It is normal for smoke to be emitted from a new 
engine after first use.

Always shut off engine before fueling. Never add fuel to 
a machine with a running or hot engine. Move at least 
30 ft. from refueling site before starting engine. Do not 
smoke! Failure to heed this warning could result in seri-
ous personal injury.

DO NOT USE E85 FUEL. IT WILL VOID YOUR  
WARRANTY.
NOTE:  Fuel system damage or performance problems re-
sulting from the use of an oxygenated fuel containing more 
than the percentages of oxygenates stated below 

covered under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume 
(commonly referred to as E10) or 15% ethanol by volume 
(commonly referred to as E15) are acceptable.

See Figures 8 - 10.
Trimmer should be on a flat, bare surface for starting. 
To start a cold engine:


Slowly press the primer bulb 10 times.

 

NOTE: After the 7th press, fuel should be visible in the 
primer bulb. If it is not, continue to press the primer until 
you see fuel in the bulb.



Set the choke lever to the 

FULL CHOKE position.



  Align the screw hole in the mounting bracket with the 

screw hole in the grass deflector.



  Insert the wing screw through the mounting bracket and 

into the grass deflector.



  Tighten the screw securely.