GE GSD6000 Manuel D’Utilisation

Step 19. 
In this step you will need the junction box cover and the 
#10 hex head screw from the screw kit set aside in Step 1.
• Secure house wiring to the back of the junction box with a 

strain relief.

• Locate the three dishwasher wires, (white, black and green) 

with stripped ends. Insert dishwasher wires through the small 
hole in the junction box bracket. Use UL listed wire nuts of 
appropriate size to connect incoming ground to green, white 
to white and black to black.

• Install the junction box cover using #10 hex head screw. 

Check to be sure that wires are not pinched under the cover.

■

  Check to be sure power is OFF.

  Check to be sure power is OFF.

■

  Open door and remove all foam and paper packaging.

  Open door and remove all foam and paper packaging.

■

  Locate the Owner’s Manual set aside in Step 1.

  Locate the Owner’s Manual set aside in Step 1.

■

  Read the Owner’s Manual for operating instructions.

  Read the Owner’s Manual for operating instructions.

■

  Check door opening and closing. If door does not open and 

  Check door opening and closing. If door does not open and 

close freely, check for proper routing of spring cable over 
pulley. If door drops or closes when released, adjust spring 
tension. See Step 2, Figure G.

■

  Check to be sure that wiring is secure under the dishwasher, 

  Check to be sure that wiring is secure under the dishwasher, 

not pinched or in contact with door springs or other 
components. See Step 10.

■

  Check door alignment with tub. If door hits tub, level 

  Check door alignment with tub. If door hits tub, level 

dishwasher. See Steps 14 and 15.

■

  Pull lower rack out, about halfway. Check to be sure it does 

  Pull lower rack out, about halfway. Check to be sure it does 

not roll back or forward on the door. If the rack moves, 
adjust leveling legs. See Step 14.

■

  Check door alignment with cabinet. If door hits cabinet, 

  Check door alignment with cabinet. If door hits cabinet, 

reposition dishwasher. See Step 15.

■

  Check that door spring does not contact water line, fill hose, 

  Check that door spring does not contact water line, fill hose, 

wiring or other components. See Step 16.

■

  Verify water supply and drain lines are not kinked or in 

  Verify water supply and drain lines are not kinked or in 

contact with other components. Contact with motor or 
dishwasher frame could cause noise. 

■

  Turn on the sink hot water faucet and verify water 

  Turn on the sink hot water faucet and verify water 

temperature. Incoming water temperature must 
be between 120°F and 150°F. A minimum of 120°F 
temperature is required for best wash performance. See 
“Prepare Hot Water Line,” page 5.

■

  Add 2 quarts of water to the bottom of the dishwasher to 

  Add 2 quarts of water to the bottom of the dishwasher to 

lubricate the pump seal.

■

  Turn on water supply. Check for leaks. Tighten connections 

  Turn on water supply. Check for leaks. Tighten connections 

if needed.

■

  Remove protective film if present from the control panel 

  Remove protective film if present from the control panel 

and door.

#282 French

If house wiring is not 2-wire with ground, a 
ground must be provided by the installer. 
When house wiring is aluminum, be sure to 
use UL Listed anti-oxidant compound and 
aluminum- to-copper connectors

06E-1774D

White

Ground

Black

White, Black and Green

Dishwasher Wires

Junction Box

Cover

Power Cord

Wires

#10

Screw