GE GSD6000 Manuel D’Utilisation

■

  Turn on power supply or plug power cord into outlet, 

  Turn on power supply or plug power cord into outlet, 

if equipped.

■

  Latch door.

  Latch door.

■

  Push “Rinse Only” button.

  Push “Rinse Only” button.

■

  Push Start/Reset pad one time. Dishwasher should start.

  Push Start/Reset pad one time. Dishwasher should start.

■

  Check to be sure that water enters the dishwasher. If water 

  Check to be sure that water enters the dishwasher. If water 

does not enter the dishwasher, check to be sure that water 
and power are turned on.

■

  Check for leaks under the dishwasher. If a leak is found, turn 

  Check for leaks under the dishwasher. If a leak is found, turn 

off power at the breaker, then tighten connections. Restore 
power after leak is corrected.

■

  Check for leaks around the door. A leak around the door 

  Check for leaks around the door. A leak around the door 

could be caused by door rubbing or hitting against 
adjacent cabinets. Reposition the dishwasher if necessary. 
See Step 15.

■

  The dishwasher will drain and turn off about 5 minutes after 

  The dishwasher will drain and turn off about 5 minutes after 

it was started. Check drain lines. If leaks are found, turn off 
power at the breaker and correct plumbing as necessary. 
Restore power after corrections are made. See Steps 7 
and 17.

■

  Open dishwasher door and make sure most of the water 

  Open dishwasher door and make sure most of the water 

has drained. If not, check that disposer plug has been 
removed and/or air gap is not plugged. Also check drain 
hose to be sure it is not kinked underneath or behind 
dishwasher. See Step 17.

■

  Press Start/Reset pad once again and run dishwasher 

  Press Start/Reset pad once again and run dishwasher 

through another “Rinse Only” cycle. Check for leaks and 
correct if required.

GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225

ge.com

© 2006 General Electric Company

        

     Pub. No. 31-30210

Dwg. No. 206C1559P150

ND 06E-1774  (6/06) 

• Place toekick against the legs of the dishwasher.

���������

����������

������

�������

• Align the toekick with the bottom edge and make sure it is 

against the fl oor.

• Insert and tighten the two toekick attachment screws. The 

toekick should stay in contact with the fl oor.

Tip: Make sure toekick is against floor to minimize noise.

• Be sure to leave complete literature package, these  

Installation Instructions and product samples and/or coupons 
with the consumer.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE