Smeg SCB64MPX5 Manuel D’Utilisation

The glass in the door should always be kept thoroughly clean. Use absorbent kitchen roll; remove stubborn dirt with
a damp sponge and ordinary detergent.

Pyrolysis is an automatic high-temperature cleaning procedure which causes dirt to dissolve.

A door interlock device means that the door cannot be opened during the procedure.
If the oven is installed underneath a hob, make sure that the burners or electric plates remain off during the
automatic cleaning cycle.

Pyrolysis may be carried out at any time of the day or night (if you wish to benefit from the lower cost of electricity
overnight). 

•  only the baking tray, the oven tray and the roof liner may be left inside the oven since they will withstand the high

temperatures of the pyrolysis process; all the other accessories must be removed from inside the oven.

•  remove the most obvious dirt (cleaning it by Pyrolysis would take too long);
•  make sure that the oven door is firmly closed;
•  when setting the cleaning cycle duration, refer to the chart below:

CLEANING DURATION:

90 MIN.

120 MIN.

180 MIN.

During the automatic cleaning cycle the fans make more noise because they are running at higher speed. This is an
absolutely normal function, intended to provide more effective heat dispersal. At the end of the pyrolysis process the
fans continue to run automatically for long enough to prevent overheating of the sides of the cabinet and the front of
the oven. 

Turn the function selector knob to the 

 symbol to start the pyrolysis cycle. The orange thermostat light comes on,

followed a few minutes later by the red “door interlock” light to indicate that the appliance's door has been locked

because of the high temperature inside the oven. As soon as the function selector knob is turned to 

, the display

shows 

 to indicate that the pyrolysis cycle will start immediately and will last an hour and a half. The duration of

the pyrolysis cycle can be increased up to a maximum of 3 hours. To do this, after the pyrolysis cycle starts press the 

key followed within a few seconds by the value modification keys 

 or 

. A few seconds after the last key is pressed,

the display will show the letter P followed by the pyrolysis duration just set, and the letter A will stop flashing. After
starting the pyrolysis procedure, and modifying its duration as just described if required, the cleaning cycle end time can
also be programmed.

Press button 

. The letter A will flash on the display, which will also show the sum of the current time plus the duration

of the pyrolysis cycle (e.g.: current time: 12.10 - Programmed duration: 2.00 - Figure shown: 14.10). At this point, the

value modification keys 

 or 

 can be used to set the cleaning cycle end time. A few seconds after the last key is

pressed, the display will show the current time and the orange light will go out; it will come back on at the preset time.