Smeg SCB64MPX5 Manuel D’Utilisation
Instructions for the User
48
7. DESCRIPTION OF FRONT PANEL CONTROLS
All the control and monitoring devices are clearly in view on the front panel. The table below provides the
key to the symbols used.
key to the symbols used.
OVEN THERMOSTAT
FRONT LEFT-HAND COOKING ZONE
FUNCTION SELECTOR KNOB
REAR LEFT-HAND COOKING ZONE
REAR RIGHT-HAND COOKING ZONE
FRONT RIGHT-HAND COOKING ZONE
Before using the oven, check that the display is showing the symbol (see point “11. ELECTRONIC
PROGRAMMER”).
PROGRAMMER”).
HOB CONTROL KNOBS
These knobs provide control of the ceramic hob's cooking zones.
The zone it controls is shown above each knob. The knob shown on the right is
for the front left-hand cooking zone.
Turn the knob to the right to set the zone's operating power; the settings range
from a minimum of 1 to a maximum of 9.
The working power is shown by a display on the hob.
The zone it controls is shown above each knob. The knob shown on the right is
for the front left-hand cooking zone.
Turn the knob to the right to set the zone's operating power; the settings range
from a minimum of 1 to a maximum of 9.
The working power is shown by a display on the hob.
Heating accelerator.
Each cooking zone is equipped with a heating accelerator.
This system allows the zone to be operated at peak power for a time proportional to the heating power
selected.
To start the heating accelerator, turn the knob to the left, select setting “A” and then release. The letter
“A” will appear on the display on the hob.
You now have 3 seconds to select the heating setting of your choice.
Once a setting between 1 and 8 has been selected, “A” and the chosen setting will flash in alternation on
the display.
While the heating accelerator is in operation, the heating level can be increased at any time. The “full
power” time will be modified accordingly.
Conversely, the heating level cannot be reduced. If the knob is turned to the right while the heating
accelerator is in operation, this will stop it immediately.
Each cooking zone is equipped with a heating accelerator.
This system allows the zone to be operated at peak power for a time proportional to the heating power
selected.
To start the heating accelerator, turn the knob to the left, select setting “A” and then release. The letter
“A” will appear on the display on the hob.
You now have 3 seconds to select the heating setting of your choice.
Once a setting between 1 and 8 has been selected, “A” and the chosen setting will flash in alternation on
the display.
While the heating accelerator is in operation, the heating level can be increased at any time. The “full
power” time will be modified accordingly.
Conversely, the heating level cannot be reduced. If the knob is turned to the right while the heating
accelerator is in operation, this will stop it immediately.