BLOOMFIELD WV-2HFG Manuel D’Utilisation

Exposed surfaces can be hot 
to the touch and may cause 
burns. 

 
1.  Press the VENTILATOR POWER switch to ON.  The green      
 

VENTILATOR POWER light will glow and the blower fan will start. 

 

After a short time, if all filters are sensed as being in position and 

 

not clogged, the cooking appliance will be energized.   

 

 

During normal operation, the VENTILATOR POWER light will be 

 

the only light glowing on the upper control panel. 

 
2.  If the amber CHECK FILTER light glows, one or more filter         
 

elements is out of position.  Check the GREASE BAFFLE,       

 

PRE-FILTER and FILTER PACK for proper installation in their    

 

respective positions.  Grease baffle and filter pack position are  

 

sensed by mechanical switches.  Pre-filter position is sensed by a 

 vacuum 

switch. 

 
3.  When the amber REPLACE PRE-FILTER light glows, the pre-filter 
 

is nearing the end of its service life.  Replace the disposable    

 PRE-FILTER 

ELEMENT. 

 
4.  When the amber REPLACE FILTER PACK light illuminates, the  
 

HEPA / Charcoal filter pack is nearing the end of its service life.     

 

Replace the FILTER PACK. 

 
 

Note:  The REPLACE PRE-FILTER  and REPLACE FILTER PACK 

lights are a warning that the indicated filter is near the end of its 

 

service life.  The appliance will continue to operate for a period of 

 

time after the light  glows to allow continued operation through a 

 

peak period. However, the indicated filters must be replaced within 

 

a reasonably short time period or they will clog and shut down    

 

electrical power to the cooking appliance .  The ventilator blower 

 

will continue to run. 

 
5.  When the red SERVICE REQUIRED light glows, either the        
 

pre-filter or filter pack (or both) is clogged and can no longer pass  

 

sufficient air to allow further operation.  The ventilator fan continues 

 

to run, but the cooking appliance  is shut down until the underlying 

 

clogged filter situation has been corrected.  This  can occur when 

 neither 

CHANGE...FILTER indicator light is lit, if both pre-filter and 

 

filter pack are marginal.  Replacing both the pre-filter and the filter 

 

pack will remedy the situation. 

Replacing the pre-filter, even  though not very dirty, will often 

 

extend the service life of the more expensive filter pack. 

 
 

Reset the unit by turning the VENTILATOR POWER switch to 

 

OFF, then back ON. 

 
6.  A failure of incoming electrical power will cause a shut down of the 
 

unit.  After power is restored, reset the unit by turning the          

 

VENTILATOR POWER switch to OFF, then back ON. 

 
NOTE:  Griddle and fryer will not operate unless the fire suppression 
system is charged, and the ventilator section is operating . 

14