Fisher & Paykel OR60 Manuel D’Utilisation

10

After installing the freestanding cooker and connecting the gas supply:

  Using a suitable leak detection fluid solution (e.g. Rocol) check each gas connection one at a 

time by brushing the solution over the connection. 
The presence of bubbles will indicate a leak. If there is a leak, tighten the fitting and then 
recheck for leaks. 

   Adjust the test point pressure or supply pressure to the value that is appropriate for the gas 

type.

  Test the operation of the appliance:

Turn on the appliance gas controls and light each burner individually and in combination.  

  

Check for a well defined blue flame without any yellow tipping. If any abnormality is

 

   

evident then check that the burner cap is located properly and the injector nipple is  

 

  

aligned correctly.

Check the minimum burner setting by quickly rotating the gas control knob from the

 

  

maximum to the minimum position. The flame must not go out. If you need to adjust the

 

  

setting, see ‘Adjusting the minimum burner setting’  following.