FCI Home Appliances COGB 33060/L/BL Manuel D’Utilisation

 

 

 

18

 

Lighting gas burners with a match is 
dangerous. You should match light the 
cooktop burners only In an emergency. 
Light a match and hold the flame near the burner 
you want to light. Wooden matches work best. 
Push in and turn the control knob slowly.  
Be sure you are turning the correct knob for the 
burner you are lighting. 
 

NOTE:  
If the burner does not light within five seconds, turn 
the knob off and wait one minute before trying again. 

 

If you attempt to measure the inner cone of the 
flame, please use caution.  
Burns could result. 

 
This appliance is shipped from the factory with low 
and medium flame settings adjusted. 

If further adjustment is necessary, proceed as follows: 
1.  Light burner and set control knob for low flame. 
2.  Remove control knob from valve stem. 
3.  Insert a slender, thin-blade screwdriver into the 

recess at centre of valve stem and engage blade 
with slot in adjusting screw. 

4.  Turn center stem adjusting screw to set flame 

size. 
• 

clockwise to reduce 

• 

counterclockwise to increase 

5.   Replace control knob when adjustment is 

completed. 

Proper adjustment will produce a stable, steady blue 
flame of minimum size. The final adjustment should 
be checked by turning knob from high to low several 
times without extinguishing the flame. 
This adjustment, at low setting, will automatically 
provide the proper flame size at medium setting. 
After Conversion Steps have been completed, check 
the appearance of each burner's flame at the Hi and 
Lo settings, if the flames appear too large or too small 
review each step to make sure it was completed 
correctly. 

This appliance is equipped for electronic auto-
reignition by means of a spark igniter located near 
each burner. The burners are designed to light at any 
valve rotation that admits sufficient gas flow to support 

a flame and to automatically relight following a loss of 
flame due to a draft or other adverse condition. This 
feature is provided as a convenience and is not 
intended as a safety feature. 

Cooktop Spark Ignition. When you turn the cooktop 
knob to LITE, the spark igniter makes a series of 
electric sparks (ticking sounds) which light the burner. 
During a power failure, the burners will not light 
automatically. In an emergency, a cooktop burner may 
be lit with a match by following the steps below. 

Turn each burner on. Flames should be blue in color 
with no trace of yellow. The burner flames should not 
flutter or blow away from the burner The inner cone of 
the flame should be between 1/2" and 3/4" long. 

 

021

COUNTERCLOCKWISE

TO INCREASE

FLAME SIZE

CLOCKWISE
TO REDUCE

FLAME SIZE

VALVE STEM

 

003

                                                                                     

COOKTOP BURNER 

-1/2” to 3/4”