GE SCB 1001 Manuel D’Utilisation

– 37 –

The humidity sensor is mounted to  the exhaust duct 
on the left side of the oven. The outer cover must be 
removed to access the humidity sensor. (See 

.) The humidity sensor is 

connected to the  power board at location CN5. The 
humidity sensor is held in place by 2 Phillips-head 
screws.

The humidity sensor detects the increasing humidity 
released during cooking. The oven automatically 
adjusts the cooking time to various types and 
amounts of food.

The oven should be plugged in at least 5 
minutes before test. 

Room temperature should not exceed 95°F. 

Be sure the interior of the oven is dry. 

No sensor cooking is available for 5 minutes 
immediately after speedcook.

Access the control panel.

Disconnect the humidity sensor wire harness from 
the power board at location CN5.

On the humidity sensor wire harness check for 
approximate resistance values between:

Black-Red = 6.5 k Ω 

Red-White = 3.25 k Ω

Black-White = 3.25 k Ω

•

•

•

•

•

•

•

Humidity Sensor

The turntable motor is held in place with 2 Phillips-
head screws. To replace it requires removing the 
turntable, turntable support, and the oven from the 
cabinet or wall opening. (See 

Removal.

) A single Phillips-head screw attaches an 

access panel to the bottom of the oven. A single 
wire harness is connected to the turntable motor.

Note: When replacing the turntable support, ensure 
it is fully seated into the "D" shaped shaft of the 
turntable motor and is fl ush with the oven fl oor. 

The turntable motor has an approximate resistance 
value of 2.6 K Ω.

Base plate cover

Wire leads

Turntable motor