Mitsubishi Electronics MELSEC-F Manuel D’Utilisation
K-15
3 Wiring
3.6 Caution Regarding Wiring
FX
3G
/FX
3U
/FX
3UC
PLC User's Manual - Analog Control Edition
FX
3U
-4AD-PNK-ADP (4-channel Resistance Thermometer Data Input)
K
FX
3U
-4A
D
D
-P
NK
-A
D
P
L
FX
3U
-4AD
-TC
-
A
D
P
M
PI
D
In
st
ru
ctio
n
(F
N
C
88
)
)
3.6
Caution Regarding Wiring
• It is not possible to connect different types of resistance thermometer to 4 channels of PNK-ADP. Be sure
to use the same type of resistance thermometer for all the channels.
3.7
Grounding
Grounding should be performed as stated below.
• The grounding resistance should be 100
• The grounding resistance should be 100
Ω or less.
• Independent grounding should be performed for best results.
When independent grounding is not performed, perform "shared grounding" as shown in the following
figure.
figure.
→ For details, refer to the User’s Manual - Hardware Edition of the PLC Series.
• The grounding wire size should be AWG22 to 20 (0.3 to 0.5 mm
2
).
• The grounding point should be close to the PLC, and all grounding wires should be as short as possible.
PLC
Other
equipment
PLC
Other
equipment
PLC
Other
equipment
Shared grounding
Good condition
Common grounding
Not allowed
Independent grounding
Best condition