Kobe Range Hoods CH0036SQB (36") Manuel D’Utilisation

Page de 36
UNDER THE CABINET INSTALLATION 
Preparation Before Installation 
NOTE:  TO AVOID DAMAGE TO YOUR HOOD, PREVENT 
DEBRIS FROM ENTERING THE VENT OPENING. 
 
 
Decide the location of the venting pipe from the hood 
to the outside.  Refer to Figure 1. 
 
A  straight,  short  vent  run  will  allow  the  hood  to 
perform more efficiently. 
 
Try  to  avoid  as  many  transitions,  elbows,  and  long 
run  as  possible.    This  may  reduce  the  performance 
of the hood. 
 
Temporarily wire the hood to test for proper operation 
before installing. 
 
Important:    Peel  protective  film  off  the  hood,  if 
any.  
 
Use duct tape to seal joints between pipe sections. 
 
For  installing  under  the  cabinet  with  recessed 
bottom,  attach  4-inch  wide  wood  filler  strips  (not 
included) on each side.  Refer to Figure 2. 
 
Using  references  in  TABLE  1  on  page  4  and 
Measurements  and  Diagrams  on  page  18,  create 
access opening for electrical wires and hood exhaust 
under the cabinet. 
 
Hood Installation 
CAUTION: If moving the cooking range is necessary 
to  install  the  hood,  turn  off  the  power  on  an  electric 
range at the main electrical box.  SHUT OFF THE GAS 
BEFORE MOVING A GAS RANGE. 
 
1.  Puncture  the  knockout  holes  (for  mounting  under  the 
cabinet) on the hood as shown in Figure 3. 
2.  Attach  ducting  transition  to  hood  exhaust  with  ten 
(3/16” x 3/8”) screws (included).  Shown in Figure 4. 
3.  If  necessary,  attach  two  rubber  stands  (included)  with 
adhesive  tape  (included)  to  the  back  corners  of  the 
hood. 
4.  Draw electrical wires through cabinet access opening. 
5.  Center the hood beneath the cabinet and flush with the 
front of the cabinet. 
6.  From  inside  of  the  hood,  place  screw  (not  included) 
into  the  center  of  each  knockout  hole  and  secure  to 
cabinet bottom.  Once all mounting screws are in place, 
finish  tightening  screws  until  secure. 
CAUTION: 
MAKE 
SURE 
HOOD 
IS 
SECURE 
BEFORE 
RELEASING. 
7.  For  safety  purpose,  pre-drilled  mounting  holes  are 
provided  through  the  back  of  the  hood.    For  a  more 
secure  installation,  use  as  many  mounting  holes  as 
needed  to  secure  from  the  inside  of  hood  (screws  not 
included). 
 
 
 
 
 
                        Figure 1 
 
 
 
 
                      Figure 2 
 
 
 
 
 
                        Figure 3 
 
Figure 4