GE Monogram ZCGS150P Manuel D’Utilisation

NOTE: Proper installation is your responsibility. Make sure you have 

everything necessary for correct installation. It is the personal 

responsibility and obligation of the customer to contact a qualified 

installer to assure that electrical installation meets all national and 

local codes and ordinances.

Gather the required tools and parts before starting installation.

■

Do not grasp control panel to move compactor.

■

Slide compactor onto cardboard or hardboard before moving 

compactor across floor to avoid floor covering damage.

■

Do not allow the rear frame of the compactor to touch the floor 

covering when lifting or moving compactor.

NOTE: Installation hardware is not provided with full cabinet models.
1. Measure the height of your cabinet opening. The top of the 

compactor should be at least 

¹₈

"

 (3

 mm) from the top of the 

cabinet opening. 
The rear wheels are preset for a cabinet opening height of 34

¹⁄₄" 

(87 cm) (Position 1).
To adjust for other cabinet opening heights:

■

Loosen self-tapping screw just enough to clear stud from 

hole in position “1.” 

■

Move the rear wheel and stud to position “2” or “3” as needed 

for your cabinet opening measurement:

Position 2: 34

¹⁄₄" to 34⁷⁄₁₆" (87 to 87.5 cm)

Position 3: 34

⁷⁄₁₆" to 34⁵⁄₈" (87.5 to 88 cm)

NOTE: To level the unit in position “3,” you may need to add 

shims under the leveling legs.

■

Tighten screw. Repeat for other rear wheel.

2. Use pliers to lower leveling legs away from cabinet. Adjust legs so 

there will be a 

¹⁄₈" (3 mm) to ¹₄" (6.4 mm) space between the top of 

the compactor and the top of the cabinet opening. Stand the 

compactor upright. 

3. For model with cabinet, remove the plastic plugs from the 

compactor cabinet top.

4. Move the compactor close to its final position.
5. Plug into a grounded 3 prong outlet.
6. Determine if you want the compactor frame or drawer front flush 

with the cabinet front.
Using the two #8-18 x 

⁵₁₆" screws, install the retaining brackets to 

cabinet top as needed:

■

If the compactor frame is to be flush with the cabinet front, 

place retaining bracket screws through “1.”

■

If the compactor drawer front is to be flush with the cabinet 

front, place retaining bracket screws through “3.”

■

If the compactor is to be midway between “1” and “3,” place 

the retaining bracket screws through “2.”

7. Slowly lift the front slightly and roll compactor into the cabinet 

opening.
Using the two #8-18 x 

¹₂" screws, fasten the retaining brackets to 

the countertop with the mounting screws.
If brackets cannot be attached to the underside of countertop, 

attach mounting clips to brackets. Fasten compactor to cabinet 

front with mounting screws through mounting clips.

■

Level

■

Phillips No. 2 screwdriver

■

Tape measure

■

Flat-blade screwdriver

■

Pliers

■

⁵⁄₁₆" Box-end wrench

■

Scissors

■

Utility knife