Samsung RF323TEDBSR Manuel D’Utilisation

 

operating

5.  Touch the “Alarm/hold 

3 sec for Filter Reset” 
button (

(Filter Reset)

) for about 

3 seconds to reset the 
water filter. The color of the 
indicator ( 

 ) changes from red to off.

6.  If you turned off the water supply, turn it back 

on.

For a replacement water filter, you can 
visit your local home Improvement center 
or contact the Samsung Parts distributor. 
Be sure the replacement water filter has 
the SAMSUNG logo on the box and 
on the water filter. Link : http://www.
samsungparts.com

Removing any residual matter inside 
the water supply line after installing 
the water filter.

1.  Turn ON the main water 

supply and supply water 
from water supply line.

2.  Run water through the 

dispenser until the water 
runs clear (approx. 6 to 7 
minutes). This will clean 
the water supply system and remove air from 
the lines.

3.  Additional flushing may be required in some 

households. 

4.  Open the Refrigerator door and make sure 

there are no water leaks coming from the 
water filter.

Be sure to flush the dispenser thoroughly, 
otherwise water may drip from the 
dispenser.  
This means that there is still air in the line.

Reverse Osmosis Water Supply 
IMPORTANT:

The pressure of the water supply coming out of a 
reverse osmosis system going to the water inlet 
valve of the refrigerator needs to be between 35 
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is 
connected to your cold water supply, the water 
pressure to the reverse osmosis system needs to 
be a minimum of 40 to 60 psi (276 to 414 kPa.) If 
the water pressure to the reverse osmosis system 
is less than 40 to 60 psi (276 to 414 kPa):

•  Check to see whether the sediment filter in the 

reverse osmosis system is blocked. Replace 
the filter if necessary.

•   Allow the storage tank on the reverse osmosis 

system to refill after heavy usage.

•   If your refrigerator has a water filter, it may 

further reduce the water pressure when used 
in conjunction with a reverse osmosis system. 
Remove the water filter.

If you have questions about your water pressure, 
call a licensed, qualified plumber.

CONTROLLING THE 
TEMPERATURE

Basic temperature of Freezer and 
Refrigerator Compartments

The basic temperature and recommended 
temperatures of the Freezer and Refrigerator 
Compartments are 0°F and 37°F (or -18°C and 
3°C) respectively. If the temperature of the Freezer 
and Refrigerator Compartments are too high or 
low, adjust the temperature manually.

Controlling the Freezer 
temperature

The Freezer temperature can be set between -8°F 
and 5°F (or between -23°C and -15°C) to suit 
your particular needs. Press the Freezer button 
repeatedly until the desired temperature is shown 
in the temperature display. The temperature will 
change by 1°F (or 1°C) with each press. See 
below.

Fahrenheit : 0°F ➞ -1°F ➞ -2°F ➞ -3°F ➞ -4°F ➞ 
-5°F ➞ -6°F ➞ -7°F  ➞ -8°F ➞ 5°F ➞ 4°F ➞ 3°F 
➞

 2°F ➞ 1°F ➞ 0°F.

Centigrade : -18°C ➞ -19°C ➞ -20°C ➞ -21°C 
➞

 -22°C ➞ -23°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ 

-18°C.
Keep in mind that foods like some ice cream may 
melt at 4°F (or -15.5°C). The temperature display 

Recommend Temp (Freezer) : 0°F (or -18°C )

DA68-02603A-03.indb   14

13. 4. 25.   �� 2:12