Samsung RFG296HD Manuel D’Utilisation

operating

 

02

 OPERA

TING

Recommend Temp (Freezer) : -2°F (or -19°C )

minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is 
less than 40 to 60 psi (276 to 414 kPa):
•  Check to see whether the sediment filter in the 

reverse osmosis system is blocked. Replace the 
filter if necessary.

•  Allow the storage tank on the reverse osmosis 

system to refill after heavy usage.

•  If your refrigerator has a water filter, it may further 

reduce the water pressure when used in conjunction 
with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call 
a licensed, qualified plumber.

CONTROLLING THE TEMPERATURE

Basic temperature of Freezer and 

Refrigerator Compartments

The basic temperature and recommended 
temperatures of the Freezer and Refrigerator 
Compartments are -2°F and 38°F (or -19°C and 3°C)
respectively. If the temperature of the Freezer and 
Refrigerator Compartments are too high or low, adjust 
the temperature manually.

Controlling the Freezer temperature

The Freezer temperature can be set between -8°F 
and 8°F (or between -22°C and -14°C) to suit your 
particular needs. Press the Freezer button repeatedly 
until the desired temperature is shown in the 
temperature display. The temperature will change by 
2°F (or 1°C) with each press. See below.
Fahrenheit :  -2°F ➞ -4°F ➞ -6°F ➞ -8°F ➞ 8°F ➞ 6°F
➞

 4°F ➞ 2°F  ➞ 0°F ➞ -2°F.

Centigrade :  -19°C ➞ -20°C ➞ -21°C ➞ -22°C ➞
-14°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ -18°C ➞ -19°C.
Keep in mind that foods  like some ice cream may melt 
at 4°F (or -15.5°C). The temperature display will move 
sequentially from -8°F to 8°F (or from -22°C to -14°C).

     •  The locked symbol should be lined up with the 

indicator line.

5.   Touch the "Alarm/hold 3 sec 

for Filter Reset" button

     (

(Filter Reset)

) for about 3 seconds to 

reset the water filter. The color of 
indicator ( 

 ) changes from red 

to blue, green, or yellow.

6.   If you turned off the water supply, turn it back on.

For a replacement water filter, you can visit your 
local home Improvement center or contact

the Samsung Parts distributor. Be sure the 
replacement water filter has the SAMSUNG logo on 
the box and on the water filter.
Link : http://www.samsungparts.com

1.   Turn ON the main water supply and supply water 

from water supply line.

2.   Run water through the dispenser until the water 

runs clear (approx. 6 to 7 minutes). This will clean 
the water supply system and remove air from the 
lines.

3.   Additional flushing may be 

required in some households. 

4.   Open the Refrigerator door and 

make sure there are no water 
leaks coming from the water 
filter.

Be sure to flush the dispenser thoroughly, 
otherwise water may drip from the dispenser. 
This means that there is still air in the line.

The pressure of the water supply coming out of a 
reverse osmosis system going to the water inlet valve 
of the refrigerator needs to be between 35 and 120 
psi (241 and 827 kPa).
If a reverse osmosis water filtration system is 
connected to your cold water supply, the water 
pressure to the reverse osmosis system needs to be a 

4

DA68-02488A-11.indb   13

14. 5. 14.   �� 11:45