Samsung RM255BASB Manuel D’Utilisation

Page de 88
DISASSEMBLY AND REASSEMBLY
The evaporator is located in the bottom of the
refrigerator.
1. Take off the partition in the refrigerator.
2. Take off the evaporator cover in the refrigerator.
3. Disconnect the wire connector.(Heater and 
Thermistor)
4. Desolder the capillary tube and the suction
line from the evaporator.
5. Remove the evaporator.
6. With a file, score the capillary tube just
upstream of the soldered point. Break off the
soldered section to help prevent solder from
plugging the tube during soldering.
7. Place a new evaporator and braze the suction 
and capillary tube to the evaporator using silver 
solder.
8. Install a replacement dryer.
9. Evacuate and recharge the system using 
reasonable procedures.
The refrigerator thermistor is located inside the
refrigerator light cover
1. Put your finger into the side groove of the lamp
cover,and pull the cover to separate.
2. Remove the screw in the lower part of
Ductwork,and pull the Thermistor cover.
3. Separate the housing inside the of Thermistor
cover, and replace the sensor.
Fresh/Arctic Select Zone Thermistor is located in the
lower part of evaporator cover
1. Unscrew both sides of the Thermistor cover.
2. Remove Thermistor cover by pulling it out.
3. Remove the tapes inside of cover, and remove
the front side Insulation to replace the Thermistor.
Refrigerator Thermistor
Fresh /Arctic Select Zone
TM
Thermistor
Evaporator in Fridge
Suction Line
Ductwork
Thermistor
Thermistor cover
Thermistor
Capillary Tube
Bimetal
Thermistor
Thermistor cover
56
56