Tektronix TVS600 & TVS600A Series Manuel D’Utilisation
INPut Subsystem
TVS600 & TVS600A Command Reference
2–123
None
INPut:FILTer
INPut:FILTer?
INPut:FILTer?
Sets or queries whether the low-pass analog noise filter is on or off for the
specified input channel. INPut:FILTer must be off to use the full bandwidth of
the waveform analyzer. To set the limit frequency of the low pass filter, use the
command INPut:FILTer:FREQuency.
specified input channel. INPut:FILTer must be off to use the full bandwidth of
the waveform analyzer. To set the limit frequency of the low pass filter, use the
command INPut:FILTer:FREQuency.
INPut<n>:FILTer[:LPASs][:STATe] <boolean>
INPut<n>:FILTer[:LPASs][:STATe]?
<n> (Channel Number)
1
Query response
1
2
3
4
2
3
4
Not applicable
1
The input channel number <n> is used by the commands INPut<n> and VOLTage<n>.
If you omit <n>, the default is channel 1.
If you omit <n>, the default is channel 1.
<boolean>
Query response
<NRf >
1 or ON
0 or OFF
1 or ON
0 or OFF
<NF1>
1
0
1
0
0 (OFF)
Execution Error –241, “Hardware missing”
Attempted to program INPut3 or INPut4 on an
instrument configured with two channels.
Attempted to program INPut3 or INPut4 on an
instrument configured with two channels.
None
Command:
INP1:FILT ON
Query:
INP1:FILT?
Response:
1
Related Commands
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples