Tektronix TVS600 & TVS600A Series Manuel D’Utilisation
TRIGger:PULSe Subsystem
TVS600 & TVS600A Command Reference
2–273
TRIGger:PULSe:GLITch:WIDTh
TRIGger:PULSe:GLITch:WIDTh?
TRIGger:PULSe:GLITch:WIDTh?
Sets or queries the width of the pulse used for pulse glitch triggering. Use the
command TRIGger:PULSe:GLITch:QUALify to set whether the trigger event is
for pulses less than or greater than the WIDTh you specify.
command TRIGger:PULSe:GLITch:QUALify to set whether the trigger event is
for pulses less than or greater than the WIDTh you specify.
Before this command will be effective, you must set TRIGger:TYPE to PULSe
and TRIGger:PULSe:CLASs to GLITch. Refer to the discussion of TRIG-
ger:PULSe:CLASs on page 2–270. The defined alias for the SCPI trigger
:SEQuence[1] is A.
and TRIGger:PULSe:CLASs to GLITch. Refer to the discussion of TRIG-
ger:PULSe:CLASs on page 2–270. The defined alias for the SCPI trigger
:SEQuence[1] is A.
TRIGger[:A]:PULSe:GLITch:WIDTh <width>
TRIGger[:A]:PULSe:GLITch:WIDTh?
<width>
1
Query response
<NRf >
MINimum
MAXimum
MAXimum
<NR3>
2.0E–9
1.0E+0
1.0E+0
1
The default for the parameter <delay_time> is seconds (S). You can also use the
multipliers MS for milliseconds, US for microseconds, NS for nanoseconds, and PS
for picoseconds.
multipliers MS for milliseconds, US for microseconds, NS for nanoseconds, and PS
for picoseconds.
2.0E–9
Execution Error –222, “Data out of range”
Attempted to set width to an illegal value.
Attempted to set width to an illegal value.
None
Command:
TRIG:PULS:GLIT:WIDT 1.0
Query:
TRIG:PULS:GLIT:WIDT?
Response:
1.0E+0
TRIGger:TYPE
TRIGger:PULSe:CLASs
TRIGger:PULSe:GLITch:QUALify
TRIGger:PULSe:CLASs
TRIGger:PULSe:GLITch:QUALify
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples
Related Commands