Tektronix TVS600 & TVS600A Series Manuel D’Utilisation
CALCulate Subsystem
TVS600 & TVS600A Command Reference
2–35
CALCulate:FILTer:FREQuency:HPASs
CALCulate:FILTer:FREQuency:HPASs?
CALCulate:FILTer:FREQuency:HPASs?
Sets or queries the limit frequency (<cutoff >) below which the filter attenuates
all frequency components. The :HPASs frequency is ignored when you select the
bandpass, notch or low-pass filter. Use the command CALCulate:FILTer:FRE-
Quency HPASs to enable the high-pass filter.
all frequency components. The :HPASs frequency is ignored when you select the
bandpass, notch or low-pass filter. Use the command CALCulate:FILTer:FRE-
Quency HPASs to enable the high-pass filter.
CALCulate<n>:FILTer[:GATE]:FREQuency:HPASs <cutoffā>
CALCulate<n>:FILTer[:GATE]:FREQuency:HPASs?
<n>
1
Query response
1
2
3
4
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
the default is calculate block 1.
<cutoff> (Limit frequency)
1
Query response
<NRf >
<NR3>
1
The default multiplier for the <cutoff > parameter is HZ for hertz. You can also use the
multipliers KHZ for kilohertz, MHZ for megahertz, and GHZ for gigahertz.
multipliers KHZ for kilohertz, MHZ for megahertz, and GHZ for gigahertz.
250.0E+6
Execution Error –222, “Data out of range”
Attempted to set the high pass cutoff frequency to an illegal value.
Attempted to set the high pass cutoff frequency to an illegal value.
None
Command:
CALC1:FILT:FREQ:HPAS 10E6
Query:
CALC1:FILT:FREQ:HPAS?
Response:
10.0E+6
CALCulate:FILTer:FREQuency:LPASs
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples
Related Commands