U-Line 75R Manuel D’Utilisation

02/2005

www.U-LineService.com

Note: It is recommended that the unit is level.

1. Use a level to check the 

levelness of the unit from 
front to back and from 
side to side. Level should 
be placed along top edge 
and side edge as shown 
(see Figure 19).

2. If the unit is not level, adjust the feet on the corners of 

the unit as necessary (see Figure 20).

3. Check the levelness after each adjustment and repeat 

the previous steps until the unit is level. Go on to 
8 Install the Unit.

If the room floor is higher than the floor in the cut-out 
opening, adjust the rear feet to achieve a total unit rear 
height of 1/8" less than the opening’s rear height. Shorten 
the unit height in the front by adjusting the front feet. 
This allows the unit to be gently tipped into the opening. 
Readjust the front feet to level the unit after it is correctly 
positioned in the opening.

1. Plug in the power cord.

2. Gently push the unit into position. Be careful not to 

entangle the electrical cord. 

3. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

1. Locate and remove the grille screw from the cabinet, 

using a standard blade screwdriver (or a 1/4" 
nutdriver). See Figure 21.

.

2. Remove the control knob by pulling it away from the 

cabinet.

3. Identify the grille screw hole on the grille itself. It is 

located toward the top of the middle recessed section 
of the grille.

Check

Level

Turn Foot to Adjust

Grille Screw