U-Line 75R Manuel D’Utilisation

www.U-LineService.com

02/2005

4. Place the two hook-hinges (located on the rear bottom 

side of the grille) onto the front lip of the unit base. 
Swing the grille up into position, aligning the grille 
screw hole on the grille to the grille screw hole on the 
cabinet. See Figure 22.

.

5. Insert the screw. Do not overtighten.

6. Reinstall control knob.

(75R Refrigerator and 75BEV Beverage Centers Only)

1. Carefully remove the glass shelves from the packaging.

2. Slide the shelves onto lower sets of ribs, making sure 

the decorative graphics are on the underside of the 
shelves. While edge strips go toward the rear and silver 
edge strips (75R Only) go toward the front. See 
Figure 23.

The unit is shipped with the control preset to a mid-point 
setting between 4 and 5. Assure that setting was not 
altered in shipment. No other adjustments should be 
necessary at this time. For information about Adjusting 
the Temperature Control, see the User Manual.

Unit does not appear to turn on when plugged in. 

Make sure outlet has power (circuit breaker has not 
tripped).

The light stays on when the door is closed. 

Make sure on/off switch is turned OFF. Check to see that 
light switch actuator bracket is contacting the light switch 
properly.

See the User Manual’s Troubleshooting Guide for more 
solutions.

Hook-Hinge

Hook-Hinge

Unit Base

Front Lip

Grille