Emerson CL-RSC Manuel D’Utilisation

2 

EMERSON CONTROL LINK CPC® P/N 818-2050 REFRIG. CONTROLLER: GENERAL PARAMETERS 

 General parameters are used by techni-

cians and operators to set the control set-
points and defrost schedules. 

 

 Before changing parameters, clear any 

active alarms by pressing the Alarm Si-
lence button.   

 

 Do not lightly press buttons!  You MUST 

 Press (SET) and hold for five seconds.  

 If general mode programming has been 

password protected, you will see PASS on 
the display.   

 Press (SET) and use the arrow keys to in-

crement the password number until the 
correct password is shown and then press 
(SET).   

 Note: If general parameters an not pass-

word protected, PASS will not appear on 
the display. 

 
The display will show the first programmable 
parameter: CSP (Case temperature Set Point).  
The arrow keys may be used to scroll through 
the list of general parameters.  To change the 
value of any parameter follow these steps: 
 
1.  Select the parameter using the arrow keys 

(until the code is shown. 

2. Press 

(SET). 

3.  Current value of this parameter will display.  

Use arrow keys to change values. 

4.  Press (SET) to accept value. 
5.  Repeat steps 1-4 until all set points have 

been properly configured. 

6.  When finished, press (SET) again for five 

seconds to save changes and exit.  The 
display will blank for one second and then 
revert to normal display if the save was 
successful. 

7.  To cancel all changes, press and hold 

(SILENCE) for five seconds, or leave con-
troller idle for 60 seconds.  You will lose all 
setpoint changes made since you entered 
General Programming Mode. 

 

SFT 

Software Version 

- -  -