Watlow Electric 986m987 Manuel D’Utilisation

WATLOW Series 988 User’s Manual

Operation Menus, Chapter 5

To reach the Operation Menus, begin in the Display Loop and press the
Mode key µ. Depending on the controller configuration, either the Set
Point 2 prompt [`SP2], the Idle Set Point prompt [IdSP] or the Operation
Menu prompt [OPEr] will appear in the lower display. The three Operation
Menus are: System [`SYS]; PID A [PidA]; and PID B [Pidb]. Use the
Mode key µ to step past the Set Point 2 prompt [`SP2] or the Idle Set
Point prompt [IdSP], if they appear (see prompt information). Upon reach-
ing the Operation Menu prompt [OPEr] use the Up-arrow > or Down-
arrow < key to select a menu and the Mode key µ to step through a
menu. 

You will not see every prompt in any of these menus. The unit’s configura-
tion and model number determine which prompts appear. After stepping
through each menu, the Series 988 returns to the Operation Menu prompt
[OPEr]. Use the Up-arrow > and Down-arrow < keys to select the next
menu, or use the Mode key µ to advance through the same menu again.
To move backwards through the menu hold the Mode key µ down and
press the Up-arrow key >. Use the Up-arrow > or Down-arrow <
key to change the prompt setting.

Chapter 5 The Operation Menus

System 

Menu 

PID A 

Menu 

PID B 

Menu 

Set Point 2

Idle Set Point

[`988]

[`SP2]

[`988]

[IdSP]

[`SyS]

[PIdb]

[PIDA]

[OPEr]

[OPEr]

[OPEr]

❶ Begin in the Display Loop, and press the Mode key
µ to reach the Set Point 2 prompt [`SP2], the Idle
Set Point prompt [IdSP] or the Operation Menu
[OPEr].

❷ Use the Mode key µ to step past the Set Point 2
prompt [`SP2] or the Idle Set Point prompt [IdSP], if
they appear (see prompt information). Upon reaching
the Operation Menu prompt [OPEr] use the Up-arrow
> key to select a menu.

˜

∂