Regency IG34-NG Manuel D’Utilisation

Regency IG34 Gas Inbuilt Fireplace

Conversion Kit #486-968 for NG to LPG Model

C

onversion Kit 486-968 Contains:

Qty. Part #  Description
1  904-345  Burner Orifi ce #51
1  918-273  Red "LPG" label
1  918-272  Label "Converted to LPG"
1 910-037  LPG Pilot Injector
1 918-823  Instruction Sheet

1)  Shut off the gas supply and unplug 

the power cord. 

2)  Remove the glass door, logs and 

lava rock.

3)  Remove the rear log tray by remov-

ing the 2 screws. (Log tray must be 
rotated to clear the burner.)

4)  Remove the grate.

5)  Remove the burner and ensure the 

aeration setting is 13 mm open.

6)  Remove burner orifi ce with a 1/2" 

wrench and discard. Use a wrench 
to hold on to the elbow behind the 
orifi ce.

16)  Remove the jumper using a plier.

7)  Reinstall new burner orifi ce LPG 

stamped #51 and tighten.

8)  Apply the conversion label  "This 

unit has been converted to ULPG" 
over top of the serial number decal.

12)  Replace the yellow "NG" label with 

the red "ULPG" label.

13)  Carefully pull out the control box.

 

NOTE: The control box is held in 
place with velcro. 

 

14)  Remove the heat shield from the 

control box by removing the 2 

screws.

15)  Remove the control  box cover  by  

undoing the 3 screws. 

       Manoeuvre through antenna. 

17)  Reverse steps 13, 12, 11, 6, 5, 4, 3 

& 2.

9)  Pull out the pilot hood by hand.

11)  Put in the new LPG orifi ce with the 

allen key. Then put back the pilot 
hood.

10)  Remove the pilot orifi ce with the 

allen key.