VTech IS6100 Manuel D’Utilisation

7

Install the headset charger as shown below.

Headset charger

Plug the small end of 

the headset charger 

power adapter into 

the power jack of the 

headset charger.

Plug the large end of the 

headset charger power 

adapter into an electrical 

outlet not controlled by a 

wall switch.

Power on the headset before use. Place the headset in the headset charger 

or press and hold   for two seconds. The   light flashes three times in blue 

and you hear three beeps when the headset is being powered on.

After installing the headset charger, charge the headset as shown below. The 

headset is fully charged after three hours of continuous charging. If the   

light does not turn on while charging, you need to charge the headset without 

interruption for at least 15 minutes to give the headset enough charge to 

use for a short time. For best performance, keep the headset in the headset 

charger when not in use. See the table on page 62 for battery operating times.

1. Place the tip of   

    the headset in the  

    small cradle on   

    the headset charger.

2. The magnet holds  

     the top of the    

     headset in place.  

     The 

 light turns  

     on when charging.

If the headset will not be used for a long time, press and hold   for two 

seconds to power off the headset. The   light flashes three times in red and 

you hear three beeps when the headset is being powered off.

The headset battery is not replaceable.