VTech IS6100 Manuel D’Utilisation

64

This telephone system accommodates one headset only. If you want to 

replace the registered headset with a new one, you must deregister the 

registered headset first (see page 65).

Place the non-registered headset in the headset charger and allow it to 

charge for at least 15 minutes before beginning registration. Remove the 

headset from the headset charger. The 

 light on the headset flashes 

slowly and alternately in red and blue.
On the telephone base of the cordless telephone, press and hold  

 

/FIND hANDSET for about four seconds until the red IN USE light    

turns on.
Immediately place the headset in the headset charger. It takes about   

60 seconds to complete the registration. The red 

IN USE light on the 

telephone base turns off. The 

 light on the headset turns red when it is 

registered but not fully charged, or turns blue if it is registered and fully 

charged.

If the registration process is successful, you hear a dial tone when you press 

 on the headset. If the registration fails, you hear “

Not registered ” through 

the headset earpiece when you press   on the headset. The   light on the 

headset flashes slowly and alternately in red and blue. To reset the headset, 

remove it from the headset charger and then place it back into its charger. Try 

the registration process again.

1.

2.

3.

You cannot register a headset if any other system handset or headset is  

in use.
The headset must be deregistered before registering it to another telephone 

system.

•

•