Leica 1000Z01 Manuel D’Utilisation
34
TPS-System 1000 Programs-2.3.1en
© Leica
OH
Plot
Generates a plot showing the measurement
configuration.
The station point is in the center and the top of the
sketch shows the direction of grid north. The sketch is
true in angular but not true in distances.
Points are numbered sequentially in the order in witch
they were measured.
Points not used in the calculation are marked with a
dotted line.
configuration.
The station point is in the center and the top of the
sketch shows the direction of grid north. The sketch is
true in angular but not true in distances.
Points are numbered sequentially in the order in witch
they were measured.
Points not used in the calculation are marked with a
dotted line.
ORINT\ PLOT
14:03
RECLC
MEAS
F1
F2
F3
F4
F5
F6
HELP
MC
1
5
4
3
2
Recalculate the result and return to the dialog
"CALCULATION RESULTS".
"CALCULATION RESULTS".
Measure more points. The program will recall the
"TARGET POINT" dialog.
"TARGET POINT" dialog.
Toggle any point ON or OFF by pressing the numeric
key corresponding to the sequence number of the point.
Note, that
key corresponding to the sequence number of the point.
Note, that
represents point 10
Exit the program.
...