Hoshizaki KM-901MAH Manuel D’Utilisation
67
Problem
Possible Cause
Remedy
[] Cloudy or irregular
cubes.
a) Evaporator
. Frozen up.
. See chart .
. Scaled up.
. Clean
3. Damaged.
3. Replace.
b) Water System
. Water supply line too
small; requires 3/8"
OD line dedicated per
machine.
OD line dedicated per
machine.
. Increase water line size.
. Water filter clogged or
flow rate too small.
. Replace filter or install a
higher flow rate filter.
3. High hardness or
contains impurities.
3. Install a water softener or
filter.
c) Spray Guide
. Dirty.
. Clean.
5. Other
Problem
Possible Cause
Remedy
[] Icemaker will not stop
when bin is filled with
ice.
ice.
a) Thermostatic Bin
Control
. Set too cold.
. See "IV.C.. Thermostatic
Bin Control Check."
. Defective.
. Replace.
b) Mechanical Bin Control . Movement restricted. . Check and free.
. Loose connection.
. Check and reconnect.
3. Defective
3. See "IV.C.. Mechanical
Bin Control Check and
Cleaning."
Cleaning."
c) Control Board ("G"
control board with
mechanical bin control)
mechanical bin control)
. Defective.
. See "IV.B. Control Board
Check."
[] Abnormal noise.
a) Pump Motor
. Bearings worn out.
. Replace.
b) Fan Motor (except
water-cooled model)
. Bearings worn out.
. Replace.
. Fan blade deformed.
. Replace.
3. Fan blade does not
move freely.
3. Replace.
c) Compressor
. Bearings worn out or
cylinder valve broken.
. Replace.
. Mounting pad out of
position.
. Reinstall.
d) Refrigerant Lines
. Rub or touch other
lines or surfaces.
. Reposition.
[3] Ice in storage bin
often melts.
a) Drain Line(s)
. Plugged.
. Clean.
b) Icemaker and Bin
. Drains not run
separately.
. Separate the drain lines.
c) Ice Cube Guide
. Out of position.
Circulated water falls
into bin.
into bin.
. Place in position.