GE jgbs80belbb Mode D'Emploi
Installation Instructions
INSTALLING THE ANTI-TIP DEVICE
Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
Locate the outside edge of the device 2
1
⁄
8
″
toward the center of the range from the marked
edge of the range.
edge of the range.
Using the device as a template, mark the position
of the hole for the screw.
of the hole for the screw.
For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail or
awl may be used if a drill is not available.
angle of 20 degrees from the horizontal. A nail or
awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need
a 1/4
a 1/4
″ x 1
1
⁄
2
″ lag bolt and a 1/2″ O.D. sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
hole for the hardware.
D
C
B
A
10
INSTALLING THE ANTI-TIP DEVICE
(CONT.)
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolt must
be properly tightened as recommended for the
hardware.
install the lag bolt through the device. The bolt must
be properly tightened as recommended for the
hardware.
Slide the range against the wall, and check for
proper installation by grasping the front edge of
the cooktop and carefully attempting to tilt the
range forward.
proper installation by grasping the front edge of
the cooktop and carefully attempting to tilt the
range forward.
E
10
WHEN ALL HOOKUPS ARE COMPLETED
Make sure all controls are left in the off position.
Make sure the flow of combustion and ventilation
air to the range is unobstructed.
Make sure the flow of combustion and ventilation
air to the range is unobstructed.
WARNING!
• Range must be secured with an approved Anti-Tip
device.
• Unless properly installed, the range could be tipped
by you or a child standing, sitting or leaning on an
open door.
open door.
• After installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
forward.
• This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
conditions.
• The use of this device does not preclude tipping
of the range when not properly installed.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
device WB2X7909.
Anti-Tip
device
device
Slotted head
screw
Wallplate
Approx. 20°
2
1
/
8
”
Marked edge of range
CONVERTING TO LP GAS (or converting back
to natural gas from LP)
to natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP gas
installer.
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP gas
installer.
The conversion instructions and LP orifices can be
found attached to the range next to the pressure
regulator.
found attached to the range next to the pressure
regulator.
Keep these instructions and the orifices in case you
want to convert back to natural gas.
want to convert back to natural gas.
Back of range
Wallboard
Wood screw
Anti-Tip
device
device
41