GE jgbs80belbb Mode D'Emploi
Before you call for service…
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Possible Causes
What To Do
Top burners do not light
Plug on range is not completely
• Make sure electrical plug is plugged into a live, properly
or do not burn evenly
inserted in the electrical outlet.
grounded outlet.
Burner hole or slits on the side
• Remove the burner heads and caps and clean them
of the burner may be clogged.
with a sewing needle or twist-tie. Make sure you do not
enlarge the holes. Check and clean the electrode area for
burned-on food or grease.
enlarge the holes. Check and clean the electrode area for
burned-on food or grease.
Improper burner assembly.
• Make sure the burner parts are installed correctly.
See the Care and cleaning of the range section.
Burner flames very
Improper air to gas ratio.
• If range is connected to LP gas, contact the person who
large or yellow
installed your range or made the conversion.
Clock does
Plug on range is not completely
• Make sure electrical plug is plugged into a live, properly
not work
inserted in the electrical outlet.
grounded outlet.
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
tripped.
Oven controls improperly set.
• See the Using the oven section.
Surface burners light
The oven gas shut-off valve
• To check the oven gas shut-off valve, remove the broiler
but oven does not
may have accidentally been
drawer or kick panel (see the Care and cleaning of the
moved during cleaning or
range section) and look for the gas shut-off lever at the
moving.
back of the range.
Display goes blank
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
breaker tripped.
The clock is turned off so that it
• See the Using the clock and timer section.
does not show in the display.
Display flashes
Power failure.
• Reset the clock.
Unable to get the
Oven control pads were
• The Bake and Broil Hi/Lo pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
Lever is
shown closed.
PULL TO OPEN.
shown closed.
PULL TO OPEN.
42
Operating
Instructions
Safety
Instructions
Installation
Instructions
Tr
oubleshooting
Tips
Consumer
S
uppor
t