Toshiba 50hp82 Manuel Du Propriétaire

37

AUTO ..............

The brightness of the screen is
adjusted automatically to suit the
picture quality.

LOCK ..............

The brightness level is set to
minimum.

OFF .................

Orbiter mode does not function.

ON ...................

The picture moves around the screen
intermittently.

OFF .................

Inverse mode does not function.

ON

..................... The picture is displayed alternately

between positive image and negative
image.
You can set the time by pressing the
PROCEED button while “ON” is set.

WT ..................

The entire screen turns white.
You can set the time by pressing the
PROCEED button while “ON” is set.

OFF .................

Screen wiper mode does not function.

ON ...................

Repeatedly moves the white vertical
bar from the left end of the screen to
the right end at a constant speed.
You can set the time by pressing the
PROCEED button while “ON” is set.

Select “RESET” from the function menu. Note that this
also restores other settings to the factory defaults.

•  Only the PLE and ORBITER can be adjusted when

an RGB signal is connected.

Set the “INVERSE” or “WHITE” display time and the
“WAITING TIME.”

Example:  Setting so that the INVERSE mode starts
in 30 minutes and proceeds for one and a half hours.

3. Use the ▲ and ▼ buttons to select “INVERSE,” then

use the 

 and 

 buttons to select “ON.”

4. Press the PROCEED button.

The “INVERSE/WT” screen appears.

5.  Adjust the time using the 

 and 

  buttons and the ▲

and ▼  buttons.
The mode switches as follows each time the 

 or 

button is pressed.

The 1st line of the “WORKING TIME”:

→

 

 ↔ 

 ↔ 

 ↔ 

 ↔ 

 ↔ 

 

←

•  The “WORKING TIME” (minutes) and “WAITING

TIME” cannot be set when the “WORKING TIME”
is “ON.”

5. Once the setting is completed...

Press the EXIT button to return to the FUNCTION
menu.
To close the main menu, press the EXIT button twice.