Mitsubishi ws-48513 Manuel Du Propriétaire

18

19

Connecting a Single Analog Antenna, Wall Outlet Cable 

Cable Box

1.  Connect the incoming cable to ANT-A on the TV back 

panel.

Note:  Connect two coaxial cables as follows:

2. One from LOOP-OUT on the TV back panel to IN on the 

cable box back panel.

3. One from OUT on the cable box back panel to ANT-B 

on the TV back panel.

Single Antenna or Wall Outlet Cable for 

Analog Broadcasts

For antennas with twin flat lead

1. For antenna with twin flat leads, connect the 300-Ohm 

twin leads to the 300-Ohm to 75-Ohm transformer.

2. Push the 75-Ohm side of the transformer onto ANT-A 

on the TV back panel.

Note: 300-Ohm to 75-Ohm matching transformers 
are not provided with the TV.  They should be 
available at most electronic stores.

For cable or antenna with coaxial lead
3. Connect the incoming cable to ANT-A on the TV back 

panel.

300 Ohm Flat

Twin Lead

Optional 300 Ohm to 75 Ohm

Matching Transformer

75 Ohm

Coaxial Cable

1

2

3

TV back panel (section detail)

IR EMITTER

NetCommand

REPEATER

Incoming

Cable

1

OUT

Cable Box

back panel section

IN

2

3

TV back panel (section detail)

Additional connection cables are 

not provided with the TV.  They are 
available at most electronic stores.

Note:  Net Command® assumes that your Cable Box 
is connected to Ant-B and your VCR.  Also, Channel 
3 is the default output channel for the Cable Box.  If 
either the connections or output channel are different, 
use the Change option of Edit NetCommand to apply 
the changes.  

Mitsubishi strongly recommends against using 
antennas with twin flat leads.  Twin flat lead antenna 
wires are subject to interference which may 
adversely affect the performance of the TV.  We 
recommend using coaxial antenna cable.

Connecting a Cable Box