Mitsubishi ws-48513 Manuel Du Propriétaire

VGA

AUDIO

IR EMITTER

NetCommand

REPEATER

ANT-A

LOOP-OUT

ANT-B

RIGHT

LEFT

VGA VIDEO

640 x 480 60Hz

M-LINK/

DVI

M-LINK

CONTROL/

RS-232C

White

Red

White

Red

Connecting MonitorLink™ with MonitorLink Control or DVI

Computer with a VGA Monitor

Figure 15

1. Connect VGA Monitor Out from the computer to VGA

Input on the TV back panel using a VGA compatible
monitor cable. See Appendix B for signal compatibility.

2. Connect the L (left) and R (right) audio cables from

the computer to VGA AUDIO on the TV back panel.
In cases where your computer’s audio output is a
single mini- jack, a splitter is needed to complete this
connection.

Note: To utilize the benefits of a digital A/V receiver,
connect your computer’s digital audio out, if available,
to a digital input on your digital A/V receiver.

CAUTION: To ensure continued FCC

compliance, the user must use a shielded

video interface cable with bonded ferrite

cores when using the VGA input, and with
bonded ferrite cores at both ends when
using the MonitorLink/DVI input.

�

��

��
��

�

��

�

��

��
��

�

��

��
��

�

��

��
��

Figure 14. Connecting MonitorLink/DVI

Figure 15. Connecting a Computer with a VGA Monitor

MonitorLink and MonitorLink Control

Figure 14

1. Connect a MonitorLink cable from the Mitsubishi

Receiver/Controller back panel to the TV back panel.

2. Connect the L (left) and R (right) audio cables from

the Mitsubishi Receiver/Controller to AUDIO LEFT and

AUDIO RIGHT on the MonitorLink section of the TV

back panel.

3. Connect the MonitorLink Control cable from the

Mitsubishi Receiver/Controller back panel to the TV
back panel.

External DVI Device with DVI-HD

Figure 14

1. Connect a DVI cable from the DVI output of the

external DVI type device to the MonitorLink/DVI-HD
input on the back of the TV.

2. Connect the L (left) and R (right) audio cables from the

external DVI device to AUDIO LEFT and AUDIO RIGHT
on the MonitorLink section of the TV back panel.

NOTE: When used as a DVI Input, MonitorLink
input is compliant with HDCP and the EIA-861
standards for standard, extended and high definition

video. This input is not intended for use with

personal computers or devices outputting video
signals with computer resolution.

Connecting a Computer with a VGA Monitor

To prevent uneven phosphor wear from

computer generated still images, turn on your
computer’s screen saver feature and set to 5

minutes or less.

IMPORTANT