Enterasys ssr-atm29-02 Mode D'Emploi
Chapter 10: Configuring Multicast Routing on the SSR
138
CoreWatch Users Guide
Configuring DVMRP Interfaces
When configuring the SSR for DVMRP, you can enable or disable that protocol on IP
interfaces. If you enable DVMRP on an interface, you can set DVMRP parameters on that
interface. To configure DVMRP interfaces:
interfaces. If you enable DVMRP on an interface, you can set DVMRP parameters on that
interface. To configure DVMRP interfaces:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Routing Configuration object.
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Multicast Routing object and then double-click the DVMRP
Routing object. Double-click the DVMRP Interfaces object.
Routing object. Double-click the DVMRP Interfaces object.
5.
Do one of the following:
–
If you are modifying the settings of an interface on which DVMRP is enabled,
double-click the DVMRP Enable Interfaces object. Then select the interface you
want to change.
double-click the DVMRP Enable Interfaces object. Then select the interface you
want to change.
–
If you are modifying the settings of an interface on which DVMRP is disabled,
double-click the DVMRP Disable Interfaces object. Then select the interface you
want to change.
double-click the DVMRP Disable Interfaces object. Then select the interface you
want to change.
–
If you are configuring a new DVMRP interface, click the Configure New DVMRP
Interface object.
Interface object.
An Interface Bound to DVMRP dialog box similar to the following appears:
Figure 71. Interface Bound to DVMRP Dialog Box