Smeg sta8614xu Mode D'Emploi

18 

Rev 0.0

Water pump-out malfunction
The appliance does not pump out the water or does so 
incorrectly. Make sure the drain hose is not kinked or 
crushed and that the siphon and fi lters are not clogged. 
If the problem persists, contact the technical assistance 
service.

Turbine fl ow-regulator malfunction 
(only for models fi tted with this feature)
The appliance is unable to precisely measure the 
quantity of incoming water. Interrupt the current program 
and switch off the dishwasher. Switch it back on again, 
program a new cycle and press start. If the problem 
persists, contact the technical assistance service.

Alternate washing system malfunction
Interrupt the current program and switch off the 
dishwasher. Switch it back on again, program a new 
cycle and press start. If the problem persists, contact 
the technical assistance service.

Water intake system malfunction
Contact the technical assistance service.

Tab. 5-01b

 

 

If an alarm situation occurs, the dishwasher interrupts the current program and 
signals the fault.

    Alarms E1, E2, E3, E4, E8, E9 immediately terminate the current program.  
Alarms E5, E6 interrupt the current program and, after the problem has been 
eliminated, resume the cycle. 
Alarm E7 is displayed at the end of the cycle which, however, is completed 
given that it does not jeopardize the operation of the dishwasher.

   To “reset” an alarm:

   open or close the door, or switch the appliance on and back off again. At this 
point, the dishwasher can be programmed again.

    

 If the fault persists, contact the Authorized Technical Assistance Ser-
vice.  

•
•

•

•