ZyXEL p-660h-61 Mode D'Emploi
Prestige 660H Series User’s Guide
21-2
Menu 1 General Setup
Table 21-1 Menu 1 General Setup
FIELD DESCRIPTION
EXAMPLE
System Name
Choose a descriptive name for identification purposes. This name can be
up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes “-” and underscores "_" are accepted.
up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes “-” and underscores "_" are accepted.
Location (optional)
Enter the geographic location (up to 31 characters) of your Prestige. MyHouse
Contact Person's
Name (optional)
Name (optional)
Enter the name (up to 30 characters) of the person in charge of this
Prestige.
Prestige.
JohnDoe
Domain Name
Enter the domain name (if you know it) here. If you leave this field blank, the
ISP may assign a domain name via DHCP. You can go to menu 24.8 and
type "sys domainname" to see the current domain name used by your
gateway.
ISP may assign a domain name via DHCP. You can go to menu 24.8 and
type "sys domainname" to see the current domain name used by your
gateway.
If you want to clear this field just press the [SPACE BAR]. The domain
name entered by you is given priority over the ISP assigned domain name.
name entered by you is given priority over the ISP assigned domain name.
zyxel.com.tw
Edit Dynamic DNS
Press the [SPACE BAR] to select Yes or No (default). Select Yes to
configure Menu 1.1 — Configure Dynamic DNS (discussed next).
configure Menu 1.1 — Configure Dynamic DNS (discussed next).
No
Route IP
Set this field to Yes to enable or No to disable IP routing. You must enable
IP routing for Internet access.
IP routing for Internet access.
Yes
Bridge
Turn on/off bridging for protocols not supported (for example, SNA) or not
turned on in the previous Route IP field. Select Yes to turn bridging on;
select No to turn bridging off.
turned on in the previous Route IP field. Select Yes to turn bridging on;
select No to turn bridging off.
No
21.2.1 Procedure to Configure Dynamic DNS
If you have a private WAN IP address, then you cannot use Dynamic DNS.
To configure Dynamic DNS, go to Menu 1 — General Setup and select Yes in the Edit Dynamic
DNS field. Press [ENTER] to display Menu 1.1— Configure Dynamic DNS as shown next.
DNS field. Press [ENTER] to display Menu 1.1— Configure Dynamic DNS as shown next.
Figure 21-2 Menu 1.1 Configure Dynamic DNS
Follow the instructions in the next table to configure Dynamic DNS parameters.
Menu 1.1 - Configure Dynamic DNS
Service Provider= WWW.DynDNS.ORG
Active= No
Host=
EMAIL=
USER=
Password= ********
Enable Wildcard= No
Press ENTER to Confirm or ESC to Cancel: