ZyXEL p-2302hw-p1 Manuel D’Utilisation

P-2302HW/HWL-P1 Series User’s Guide

Chapter 7 LAN

123

Figure 59   Network > LAN > DHCP Setup

Each field is described in the following table.

Note: This screen has no effect if the DHCP server is not enabled. You can enable it 

in Network > LAN > DHCP Setup.

Table 49   Network > LAN > DHCP Setup

DHCP Setup

Enable DHCP 
Server

Select this if you want the ZyXEL Device to be the DHCP server on the LAN. As a 
DHCP server, the ZyXEL Device assigns IP addresses to DHCP clients on the 
LAN and provides the subnet mask and DNS server information.

IP Pool Starting 
Address

Enter the IP address from which the ZyXEL Device begins allocating IP addresses, 
if you have not specified an IP address for this computer in Network > LAN > 
Static DHCP.

Pool Size

Enter the number of IP addresses to allocate. This number must be at least one 
and is limited by a subnet mask of 255.255.255.0 (regardless of the subnet the 
ZyXEL Device is in). For example, if the IP Pool Start Address is 10.10.10.10, the 
ZyXEL Device can allocate up to 10.10.10.254, or 245 IP addresses.

DNS Server

First DNS Server

Second DNS 
Server

Third DNS Server

Specify the IP addresses of a maximum of three DNS servers that the network can 
use. The ZyXEL Device provides these IP addresses to DHCP clients. You can 
specify these IP addresses two ways.

From ISP - provide the DNS servers provided by the ISP on the WAN port.

User Defined - enter a static IP address.

DNS Relay - this setting will relay DNS information from the DNS server obtained 
by the ZyXEL Device.

None -  no DNS service will be provided by the ZyXEL Device.

Apply

Click this to save your changes and to apply them to the ZyXEL Device.

Cancel

Click this to set every field in this screen to its last-saved value.