Affirmative 7370 Mode D'Emploi
designed to protect external file systems, such as a FAT file system on a CompactFlash card. NOTE:
Holding on to the button may not engage Suspend/Resume – it may only dim the display.
Holding on to the button may not engage Suspend/Resume – it may only dim the display.
Reset to Factory Defaults
There may be occasions where you want to reset the YEStablet 7370 to the default state, just as it was
delivered from the factory. The procedure is:
1. Press and hold the Reset button (
power.
2. Press the Reset button again to turn on the power and quickly (BEFORE the display shows the
LOGO) press and hold the Virtual Keyboard button (
) AND the 4-Way Right button
) simultaneously. You should see the following selection menu on the screen:
• Launch WinCE OS
• Clear Registry
• Clear FileSystem
• Clear FileSystem
• EBoot
• Update via Cradle USB
• Check Flash Memory Size
• Check Flash Memory Size
3. Use the 4-Way Down button, (
) to move the cursor down to Clear FileSystem..
4. Press the Virtual Keyboard button on the device front bezel.
NOTE: You will not be asked to
confirm your action, so be sure this is what you want to do before pressing the Virtual
Keyboard button.
Keyboard button.
If you want to renege on your decision, just execute a
at this point.
5. An "Erasing flash…" message will appear, followed in several seconds by a “Programming
flash…” message. When that is finished, the 7370 will automatically reboot, and you can begin
Battery and Power Management
The YEStablet 7370 is equipped with an internal Li-Ion battery pack that is capable of supporting
approximately 2.5 hours of continuous operation. The period of continuous operation can be extended
to approximately 6 hours with the aid of an optional external battery pack that clips onto the back of the
device. The operation time can be significantly lengthened by putting the device into Suspend mode
through the Suspend button (
approximately 2.5 hours of continuous operation. The period of continuous operation can be extended
to approximately 6 hours with the aid of an optional external battery pack that clips onto the back of the
device. The operation time can be significantly lengthened by putting the device into Suspend mode
through the Suspend button (
) whenever the device is not in use. The YEStablet 7370 may
also be configured to automatically enter into power-saving modes after user-definable periods of
device idle (see
device idle (see
).
The YEStablet 7370 battery pack may be recharged with the provided AC-DC adapter connected
directly to the DC-in jack on the device or connected to the device cradle. Allow one-to-two minutes of
charging time for every minute of operation.
An auxiliary battery charger is available for the optional external battery, so that spare batteries can be
charged while the YEStablet 7370 is in portable use. In most cases, one spare battery and one auxiliary
charger should allow continuous use; two spare batteries should insure continuous use under even the
heaviest 7370 use, if you are diligent in recharging the external batteries after they become discharged.
37