Brother MFC-P2000 Guide D’Installation Rapide

- 18 -

Sleep Mode
When the machine does not receive data for a certain period of time (time-out), it enters
sleep mode. Sleep mode acts as though the machine was turned off. The default time-
out is 5 minutes. While the machine is in sleep mode, all the 

 are off and it is as

if it was turned off, but the machine can still receive data from the computer. Receiving
a print file or document automatically wakes up the machine to start printing. Pressing
the switch also wakes up the machine.

✒

 When the machine goes into sleep mode, the fan will not stop until the print engine

has cooled down.

 Sleep mode allows the print engine to cool, so the temperature of your room and how

long the machine has been in sleep mode affects the warm-up time. This warm-up
time can take up to 30 seconds. The 

 lamp blinks to indicate that the machine

is warming up.

 You can change the timeout for sleep mode with the supplied machine driver or

Remote Printer Console program . Refer to the Help section in the printer driver or
RPC program for more information about the sleep mode setting.

Test Print Mode
The machine has the following test print mode. Follow these steps:

1. Make sure that the top cover is closed.
2. Hold down the switch and turn on the 

 switch. Keep the switch depressed

until the 

 lamp comes on.

The 

 lamp lights to indicate that the machine is in the test print mode.

3. Press the switch again to execute the test print or hold down the switch to select

another option and release the switch to execute the selected option.
The test print modes are as follows:

Test sample
page

The machine prints a test sample page.
The machine returns to the ready status after printing.

Print Config
& Print Fonts I

The machine prints the current configuration of the
machine and a list of the internal fonts.
The machine returns to the ready status after printing.

Factory Reset

The machine is restored to the factory setting and
permanent fonts and macros are cleared.
The machine returns to the ready status after printing.

Hex Dump
Print

The machine can print data as hexadecimal values, so that
you can check data errors and problems. To exit from this
mode, you have to turn off the machine.