Argox pt-10 Manuel D’Utilisation
36
Data is corrupted, or no data is transmitted
Is the proper baud rate selected?
The computer needs the same baud rate as the collector.
The computer needs the same baud rate as the collector.
Make sure the interface connectors of cradle and/or collector are
well connected and clean the connectors if necessary, and try
again.
well connected and clean the connectors if necessary, and try
again.
The collector looses data when the battery pack is removed for a short period
The backup battery is empty
Recharging again with the main battery and backup battery. If the
backup battery is still empty, the collector needs to be sent back to
your local supplier or Argox to replace with a new one.
backup battery is still empty, the collector needs to be sent back to
your local supplier or Argox to replace with a new one.
7.3 Read Operation Problems
When the collector has a problem with reading the barcode label
The resolution of the bar code is too high
Decrease the distance between the bar code and the collector.
The angle between the label and the collector is too high
Change the angle between the bar code and the collector.
The distance is too far or too close
Change the distance between the bar code and the collector.
The bar code is larger than the LED light beam
Try moving the collector a bit further away from the bar code.
The scanning window is dirty
Clean the scanning window slightly of the collector (make sure
without scratch).
without scratch).
The type of the bar code label is not enabled
Enabled the bar code symbology in the application program.