Cleveland oeb-10.10 Manuel De Montage

 

 

These operating irregularities do not have error messages. 

Suction plate not correctly locked 

Lock suction plate correctly 

Nominal oven temperature too high 

Select lower temperature and increase 
cooking time 

Not pre-heated 

Always pre-heat  

Bypass pipe greasy 

Clean bypass 

Uneven browning 

Incorrect accessories, container 

Use suitable accessories 

Control elements not illuminated and 
do not react when switched on 

No power connection, external failsafe 
triggered 

Call customer service 

Combi does not react to information 

entered 

Software has hung itself up 

Hold down the ON/OFF switch for 5 
seconds or disconnect Combi for 5 
seconds 

Combi cannot be switched on or off 

ON/OFF has been locked for 3 
seconds 

Try again after 3 seconds 

Oven is not lit inside 

Oven light fault 

Call customer service 

Steam measuring line blocked 

Clean steam measurement line; see 
“Daily servicing and maintenance” 

Water sprays from air outlet when door 
is closed 

Combi drain blocked 

Clean outflow 

Water sprayed out of steam generator 
into oven during operation 

Automatic rinsing of steam generators 
has not been carried out for some time, 
i.e. it is continually deselected 

Descale steam generators 

Water inside the oven 

Outflow blocked 

Rinse condenser and outflow 
thoroughly, clean/check own drain 
system 

Outflow connection blocked or covered  Remove object 

Water running out of base of Combi 

Outflow blocked 

Rinse condenser and outflow 
thoroughly, clean/check own drain 
system 

Incorrect cleaning agent 

Use original CONVOClean forte or new 
cleaning agents 

Black marks inside oven 

Water hardness too high 

See Water Quality Recommendations 
in Warranty 

Water pressure too low 

Increase pressure at installation 
location 

Incorrect cleaning agent 

Switch to CONVOClean 

Automatic cleaning (CONVOClean 
system) gives poor cleaning results 

Degree of soiling incorrectly set 

Select higher cleaning level