Garmin 5008 Manuel Du Propriétaire

a

ppendIX

Your unit’s touchscreen does not normally require calibration. However, if the buttons do not seem 

to be responding properly, use the following process to calibrate the screen.

1.  While the unit is turned off, press the  

key.

2.  When the Warning screen appears (with the

button), touch anywhere on the black

portion of the screen for approximately 15 seconds until the Calibration screen is displayed.

3.  Follow the instructions on the screen until “Calibration is complete” is displayed.
4.  Touch

.

The GPSMAP 4000 series unit can accept data from both NMEA 0183 compliant devices and 

certain NMEA 2000 devices connected to an existing NMEA 2000 network on your boat.

The NMEA 0183 data cable included with the GPSMAP 4000/5000 series chartplotter supports the 

NMEA 0183 standard, which is used to wire various NMEA 0183-compliant devices, such as VHF 

radios, NMEA instruments, autopilots, wind sensors, and heading sensors.
The GPSMAP 5000 series unit can receive data from up to four NMEA 0183-compliant devices and 

send GPS data to up to six NMEA 0183-compliant devices.
To wire the GPSMAP 5000 series unit to optional NMEA 0183-compliant devices, see the GPSMAP 

4000/5000 series installation instructions.

GPBWC, GPRMC, GPGGA, GPGSA, GPGSV, GPGLL, GPBOD, GPRMB, GPRTE, GPVTG, 

GPWPL, GPXTE, and Garmin proprietary sentences PGRME, PGRMM, and PGRMZ.
This unit also includes support for the WPL sentence, DSC, and sonar NMEA 0183 input with 

support for the DPT (depth) or DBT, MTW (water temp), and VHW (water temp, speed, and 

heading) sentences.

  NOTE: To configure how the unit sees these NMEA 0183 sentences, see 

.

The GPSMAP 4000/5000 series unit is NMEA 2000 certified, and can receive data from a NMEA 

2000 network installed on the boat to show engine specific information on the gauges section of the 

Information screen. Also, the unit can receive heading data from a heading sensor connected to an 

installed NMEA 2000 network.