Aethra d2000 lite Manuel D’Utilisation
ISDN TESTER AND ANALYZER D2000
PRO
/D2000Lite/D2000 USER’S MANUAL
3.2. Opening the Manual Test Screen
To select the manual test:
1
Open the TEST MENU.
The last used setup appears on the screen.
The last used setup appears on the screen.
2
Select the ACCESS field.
3
Select the access type, eg. ISDN PRIMARY or BASIC or
POTS
POTS
4
Select the ACT AS field.
5
Select the instrument mode, eg. NT-U.
The lower section of the screen shows the network
configuration in use. The yellow LED that corresponds to
the selected mode goes on. The available instrument
modes are shown in Table 2-1.
configuration in use. The yellow LED that corresponds to
the selected mode goes on. The available instrument
modes are shown in Table 2-1.
6
Select MANUAL TESTS.
The following screen appears:
The following screen appears:
7
Choose the test you want to perform.
8
Once configured all the parameters regarding the test
chosen, select °Use this setup for testing°.
chosen, select °Use this setup for testing°.
Each test is described in the following pages.
34
CHAPTER 3 - PERFORMING A MANUAL TEST